Buttplate Winchester 1894 pre 64

This a butt plate pre-64 Winchester 1894 carbine. It is a reproduction of an original butt plate made from high-quality black urethane. This will fit guns with serial numbers less than 2,500,000. Each butt plate comes with fitting instructions, as some minor fitting MAY be required, but not always. Dimensions are as follows; Overall Length is 4 3/4 inches; Width at widest point is 1 5/8 inches. From top of plate to center of top screw hole is just under 6/8 inches and from bottom of plate to center of bottom screw hole is 5/8 inches. The Center to center of screw holes is 3 3/8 inches (allow slight variance in measurements, because the holes in the buttplates are much larger than the holes in your stock (they are counter sunk screw heads). To attach the plate to your stock, use buttplate screws wp57.