This NEW buttplate fits Winchester models 60, 61, 1910, 67, 67A, 69, 72 and 1904. It is a reproduction of an original buttplate made from high-quality black urethane. Your buttplate comes with fitting instructions, as some minor fitting MAY be required, but not always. Dimensions are as follows; Overall Length is 4 14/16 inches; Width at widest point is just under 1 1/2 inches. From top of plate to middle of top screw hole is 9/16 and from bottom of plate to middle of bottom screw hole is 1 inch. The center to center measurement of the screw holes (from center of holes) is 3 1/16 inches. This buttplate as well as the 802 buttplate can be used to replace the flat checkered metal buttplate on the 1894 carbine/rifles--compare measurements. (NOTE: model 61 compare screw hole locations to the 881 butt plate on your rifle, the model 61 more commonly used the 881 buttplate measurements. This is also the buttplate Winchester model 62 - 62A (if your top screw hole is 9/16 from the top of your stock). In case you need an ORIGINAL PLEASE LOOK AT PART # BP890 for the original factory buttplate .
