Buttplate Winchester ORIGINAL checkered flat Metal model 61, 1910, 67, 67A, 69, 72, 1904, later 1894

This is an ORIGINAL buttplate that fits a number of Winchester rifles, including models 61, 1910, 67, 67A, 69, 72 and 1904 and the later 1894 pre 64 carbines. This is also the buttplate Winchester model 62 - 62A (if your top screw hole is 9/16 from the top of your stock). Your buttplate comes with fitting instructions, as some minor fitting MAY be required, but not always. Dimensions are as follows; Overall Length is 4 14/16 inches; Width at widest point is just under 1 1/2 inches. From top of plate to middle of top screw hole is 9/16 and from bottom of plate to middle of bottom screw hole is 1 inch. The center to center measurement of the screw holes (from center of holes) is 3 1/16 inches. This buttplate as well as the 802 buttplate can be used to replace the flat checkered metal butt plate on the 1894 carbine/rifles--compare measurements. (NOTE: model 61 compare screw hole locations to the 881 butt plate on your rifle, the model 61 more commonly used the 881 butt plate measurements). Original buttplate screws post-64 model 94 rifle with the Phillips head are part number wp284 wop. All other models use screw wp57. You can clicking on the dropdown list below to add wp57's at a discounted price!


$56.00

  • Item Id: bp897 wop
  • 3 - Available
  • Origin: Winchester Original Part

Add to Cart:

Additional Images



Copyright © 2020 Homestead Parts. Parts for Antique Firearms of the Old West: Winchester and Remington
wastrong template