An ORIGINAL front barrel band Winchester 1982 and 1894 carbines. This band sits right behind the front sight. The screw for this band is part number wp63. (if you need the band that goes around the wood Forearm this si the THE REAR band-- see rear band wp10).
Bolt COMPLETE Winchester 1902, This ORIGINAL bolt contains the firing pin, cocking knob, and firing pin spring, all held in place by two pins. Ready to inset directly into your gun and start firing.
Buttplate Remington model 1000 in 12 gauge. It is an original buttplate made in the US, Your buttplate comes with fitting instructions, as some minor fitting MAY be required, but not always. Dimensions are as follows; Overall Length is 4 7/8 inches; Width at widest point is 1 3/4 inches. From top of plate to center of top screw hole is 1/2 inches; from bottom of plate to center of bottom screw hole is 1 ? inches. The center to center measurement between the screw holes is 3 1/8 inches... CLICK HERE for More Info or to Order
This is an ORIGINAL blued metal buttplate Winchester Model 63. No checkering , metal is SMOOTH . Use buttplate screws wp69. This will not work on your 1903 rifles as they have a smooth metal buttplate that looks similar but has a much deeper curve.
An ORIGINAL metal forearm tip (forForearm cap) model 63 and 1903 Winchester. This part is heavy solid metal with crisp forearm screw holes in the sideand the swing swivel eye on the bottom of the fore arm cap .
This is an ORIGINAL forearm tip (cap) for the Winchester 1894 and 1892 (pre 64). It fits the 30-30, .38 & .44 cal lever-action rifle ROUND barrels in the rifle and carbine. FYI: the round barrel forearm caps are hard to find. If you are good with a file you can take metal off of the inside of the octagon forearm cap and contour it to the round barrel.
This is an ORIGINAL locking bolt for the pre 64 Winchester 1894 and Model 64 and Model 55 . It is .005 oversized to compensate for excessive head space on your rifle.
This is magazine tube Winchester model 1886 rifle WITH A 24" BARREL. It is drilled through on the end for the magazine plug screw. If you have the carbine OR need a longer tube,see part number mt86-C. Use magazine spring part number ms86 and follower wp721-a Tube measurements; OD is .720, ID is 634 (mag plug has NO LIP FOR THIS TUBE).
This is magazine tube Winchester model 1886 rifle WITH A 26" BARREL. It is drilled through on the end for the magazine plug screw. If you have the carbine OR need a longer tube,see part number mt86-C. Use magazine spring part number ms86 and follower wp721-a Tube measurements; OD is .720, ID is 634 (mag plug has NO LIP FOR THIS TUBE).