An ORIGINAL front barrel band Winchester 1982 and 1894 carbines. This band sits right behind the front sight. The screw for this band is part number wp63. (if you need the band that goes around the wood Forearm this si the THE REAR band-- see rear band wp10).
Barrel Hamilton Model 23 GOOD - bore is good with rifling and shiny lands withmarkings. Still some cover on metal and lower barrel element and front sight included.
Barrel for a Stevens model 70 (Visible Loader) in EXCELLENT condition ORIGINAL. Barrel metal has from 50-90 percent original bluing. Bore still has good rifling with markings in the lands.
An early production Barrel Stud for the Stevens Crackshot Model 17. This stud screws into the lower barrel and the stock screw attaches stockto barrel.
Bolt COMPLETE Winchester 1902, This ORIGINAL bolt contains the firing pin, cocking knob, and firing pin spring, all held in place by two pins. Ready to inset directly into your gun and start firing.
These are ORIGINAL bolts COMPLETE - made specifically Winchester model 62A pump 22 rifle with pins that hold the firing pin stop in place (sometimes called the 3 pin bolt). These bolts are in excellent condition A rare find serious Winchester Collector and model 62A restoration specialist. They are COMPLETE with pins , extractors and firing pin . Bluing cover REMAINING TO VARYING DEGREES as these are used parts.
This is a buttplate for the L.C. Smith 12 Gauge Buttplate Fat Size (1/2" Thick). This ORIGINAL buttplate has a logoof hunting dogsin thecenter. It is a reproduction of an original buttplate made in the US, from high-quality urethane. Your buttplate comes with fitting instructions, as some minor fitting MAY be required, but not always. Dimensions are Approximately 4 7/8" X 1 7/16". Allow for a slight variance in... CLICK HERE for More Info or to Order
This is the metal buttplate 1894 or 1892 Carbine lever action Winchester. It fits pre and post 64 1894 rifles. (The later pre 64 1894's and the POST 64 model 94 also came with the flat checkered metal buttplate). It has been blued and is ready to install. The buttplate screws that will fit are wp57. If you would like a NON blued buttplate look at part number 879.
This is an ORIGINAL blued metal buttplate Winchester Model 63. No checkering , metal is SMOOTH . Use buttplate screws wp69. This will not work on your 1903 rifles as they have a smooth metal buttplate that looks similar but has a much deeper curve.
Winchester 1900, 1902, 1904, 58, 99 and 36 stock stud screw ORIGINAL escutcheon. This part screws into the forend wood stock where the stock stud (assembly screw) goes through and fastens into the bottom of the barrel. The escutcheon keeps the shaft of the screw from wearing out the wood around the hole.