Buttplate Winchester model 21 and 101 in 12 gauge

$19.50

Buttplate for Winchester models 21 and 101 in 12 gauge. It is a reproduction of an original butt plate made from high quality urethane. It has (round logo Winchester repeating and trademark) on the front and also has a slight curve. Your butt plate comes with fitting instructions, as some minor fitting MAY be required, but not always. Dimensions are as follows; Overall Length is 4 7/8 inches; Width at widest point is 1 1/2 inches. The middle of top screw hole to top of buttplate is 3/8 inches. The Middle of bottom screw hole to bottom of buttplate is 1 1/8 inch. The center to center of the screw holes (from middle of holes) is 3 3/8 inches (allow slight variance in measurements , because the holes in the buttplates are much larger than the holes in your stock (they are counter sunk screw heads). To attach the plate to your stock, use buttplate screws wp57. If your stock is slightly larger see buttplate 882-b

  

This item is
temporarily unavailable.

  • Item Id: bp882-a
  • Shipping Weight: 0.4lbs
  • 0 - Available

Please Choose:




Let us notify you when this product is back in stock!

Simply enter your details below and we will send you an e-mail when “Buttplate Winchester model 21 and 101 in 12 gauge ” is back in stock!

We will not send you any other e-mails or add you to our newsletter, you will only be e-mailed about this product!





Copyright © 2021 Homestead Parts. Parts for Antique Firearms of the Old West: Winchester and Remington
wastrong template