Buttplate that fits the Winchester model 12 in 12 gauge. It also fits Winchester model 24, model 1911 and model 37. I have found that this is more commonly used on the 16 gauge as well. It is a reproduction of an original buttplate made from high quality urethane. Your buttplate comes with fitting instructions, as some minor fitting MAY be required (not always). Dimensions are as follows; Overall Length is 5 1/16 inches; Width at widest point is 1 1/2. From top of plate to center of top screw hole is a 3/8 inches; from bottom of plate to center of bottom screw hole is 1 3/8 inches. The center to center measurement of the screw holes (from center of holes) is, 3 3/8 inches (allow slight variance in measurements, because the holes in the buttplates are much larger than the holes in your stock (they are counter sunk screw heads). To attach the plate to your stock, use buttplate screws wp57.
