This is the Remington RA buttplate with a spur (claw) on top. It is smaller than the other clawed RA buttplates. It is a reproduction of an original buttplate made in the US, from high-quality urethane. Your buttplate comes with fitting instructions, as some minor fitting MAY be required, but not always. Dimensions are as follows; Overall Length is 5 1/4 inches; Width at widest point is 1 1/2 inches. Top screw hole is at the top of the stock; from bottom of plate to center of bottom screw hole is 1 1/2 inches. The center to center measurement between the screw holes is 3 1/2 inches (allow slight variance in measurements, because the holes in the buttplates are much larger than the holes in your stock (they are counter sunk screw heads). To attach the plate to your stock, use buttplate screws wp57.
