This is an ORIGINAL checkered metal buttplate made for POST 64 94 Model. Fits a number of Winchester rifles, including models 61, 1910, 67, 67A, 69, 72 and 1904 and the later 1894 pre 64 carbines. This is also the buttplate Winchester model 62 - 62A (if your top screw hole is 3/4 from the top of your stock). Some minor fitting MAY be required, but not always. Dimensions are as follows; Overall Length is 4 5/8 inches; Width at widest point is 1 7/16 inches. From top of plate to middle of top screw hole is 13/16 and from bottom of plate to middle of bottom screw hole is 1 1/16 inch. The center to center measurement of the screw holes (from center of holes) is 2 7/8 inches. This buttplate as well as the 802 buttplate can be used to replace the flat checkered metal butt plate on the 1894 carbine/rifles--compare measurements. (NOTE: model 61 compare screw hole locations to the 881 butt plate on your rifle, the model 61 more commonly used the 881 butt plate measurements). Original buttplate screws post-64 model 94 rifle with the Phillips head are part number wp284 wop. All other models use screw wp57. You can clicking on the dropdown list below to add wp57's at a discounted price!
