HP-Make

This is the tiny little pin that goes into the end of the assembly screw (take down screw) on the Winchester 1890 - 1906, mod  62 and also fits...

In 1935 Winchester changed its locking system from using the protrusion on the firing pin as the breech bolt lock to this new system. If you...

This is the BLUED crescent metal buttplate Winchester 1890 pump .22 and the LEVER ACTION 1894 - 1892 - 1895 and late 1886 RIFLE. The Winchester 1873...

This is the pin cartridge cut off on the Winchester model 61. It is also lower extractor

This is the pin that holds the cartridge stop (wp3A) in the carrier of the Winchester 1906 and 62 or 62A. If you have a carrier that only holds the...

A set of a 4-piece cleaning rod 1866 and 1873 Winchester sporting rifle. These are made in the USA. These rods will fit in the 38-40 or 44-40 stock...

This is the ejector collar Winchester 1886 lever action rifle. This part holds the ejector spring onto the ejector.

This is the ejector spring Winchester 1886 lever action rifle. It fits over the neck of the ejector and was held in place by the ejector collar.

This is the pin that holds the .22 cal extractor onto the top of the breech bolt on the Winchester .22 cal 1873 Rifle.

This is the extractor pin Winchester 1873 large .38 and .44 cal extractor.

Fits Winchester model 1894/64/55 and Winchester 1892/65/53. This is the pin that goes through the Forearm of the finger lever and attaches it to the...

This is the pin that attaches the finger lever to the link (part on under side of receiver) on the Winchester 94 POST 64. This is not the pin that...

Spring that sits behind your friction stud (p158) on the Forearm of your link. This spring puts tension on the friction stud which keeps your finger...

This is the Loading gate screw also called spring cover screw Winchester 1873. This unique screw has an OVAL head and is designed to fit rifles with...

This is the magazine follower Winchester 1892 .25-.20 /.32-.20. also model 65 and 53. This part sits in the receiver Forearm of the magazine tube and...

This is the magazine follower Winchester 1876 all cals. This part pushes the bullets to the receiver.

This is the saddle ring and staple Winchesterchster 1866, 1873 and 1892. This came from the factory pressed into the receiver.

This is the saddle ring and stud assembly SPECIFICALLY Winchester 1895. It is the same as the saddle rings used on the 1894, 1873 and 1886 but the...

This is the safety catch pin Winchester 1873, 1894 and 1876 lever action rifle. This pin holds the safety bar in the lower tang (also called trigger...

This is the receiver side tang screw FIRST model 1873. This screw attatches the lower receiver tang to the main frame on the rifle. The length is...

This is a steel front sight blade Winchester 1873, 1892, and 1894 lever action rifles. These are 0.455 high. These are found on the 1892 carbines...

Both the front and rear toggle link pins were the same dimention Winchester 1873. This pin will fit the front or the rear of the toggle links

This is the pin that holds the trigger in place on the Winchester 1890, 1906 , 62, 62A