Num

Bushing that goes throught the carrier and holds hammer and take-down screw in place. This part fits model 90 or 06, 62 or 62A. If your carrier...

This is the front barrel band in GOLD Winchester 1892 or 1894 pre and post 64. It comes with a blued band screw. This is the band that sits behind...

This is the rear barrel band in GOLD Winchester 1892 or 1894 pre and post 64. It comes with a blued band screw. This is the band that attaches the...

This is the rear band screw Winchester model 1895 carbine. This screw goes through the band that hold the wooden foream onto the rifle.

This is a new carrier BLOCK for the Winchester 1873 rifle or carbine. It fits the large cal rounds (44/38 cal) fitting may be required (usually, but...

This is the carrier spring Winchester 1895 lever action rifle. It is the type 2 coil style that was used after serial number 50,000.

This is the carrier stop Winchester 1892 in 38-40 and 44-40 cal rifles. A pin holds the carrier stop and carrier stop spring in on the left side of...

This is the ejector spring Winchester 1895. This spring provides the tension against the ejector needed to eject the cartridge case.

This is the LARGE LOOP finger lever Winchester 1894 rifle. This is a replica of the figer lever that was used in the hit TV series The Rifleman. This...

This is the finger lever lock plunger spring 1895 Winchester.

This is the part on the Winchester 1895 that (unlike model94) does not fully block the rear of the breechbolt. It slides up into milled section on...

This is the screw that holds on the forearm cap Winchester model 94 POST 64

This is a NEW forearm tip (cap) for the Winchester 1894 and 1892 (pre 64). It fits the 30-30, .38 & .44 cal lever-action rifle ROUND...

This is the little pin that holds the friction stud in place on the finger lever of the Winchester 1892 lever action rifle

This is the hammer stirrup Winchester 1892 and 1894 lever action rifles. This part attaches to the hammer by pin p148. The Forearm of the mainspring...

This is an Original magazine follower Winchester 1890 1906 62 62A 61 inner magazine tube in Sort, Long and Long Rifle.

This is the screw that holds the magazine lever (part number 575) onto the Forearm plug takedown model Winchester 1892 small cal rifles (32-20 and...

This is the lever that goes into the magazine plug on the Winchester 1892 take down 25.20 and 32.20 cal riles. This lever is 1/3 and 3/4 length...

This is the small caliber magazine tube for .25 WCF .25-.20, .32 WCF .32-.20 and .218 Bee - Winchester 1873, 1892, 52 and Marlin lever action rifles...

This is the highest 4-step rear sight elevator for lever action Winchester rifles. This elevator fits 1873, 1886, 1894 (pre and post 64) and 1895....

This is the 4-step rear sight elevator lever action Winchester rifles. This elevator fits 1873, 1886, 1894 (pre and post 64) and 1895. Winchester...

This is AN ORIGINAL takedown screw (also called the assembly screw) for the Winchester model 1903 and model 63. The stop pin for this part is p110...